37 / 54OUTPUT · DEEP GUIDE

Cut a capture into slices later

You do not have to decide to slice before you capture. Any result can be cut afterwards, into rows or columns, at the places you choose, and handed over as the same numbered ZIP that Slices mode makes.

A tall capture on the result page cut into four slices, with a cut line and a pixel label at each boundary and the slicing controls along the bottom
FIG. 37 / A full-page capture cut into four equal slices. The bar along the bottom holds the slicing controls.OPEN FULL SIZE ↗
01

Open the slicer

On a finished capture, choose Slice from the result toolbar. The bar changes to the slicing controls and the capture stays in view, with a ruler down its left side. Nothing is cut until you press the button on the right of the bar, which says how many slices it will make.

02

Place the cuts

There are three ways to place cuts, and you can mix them:

A capture cut into four slices, each labelled with its height in pixels
Each slice is numbered and labelled with its height. The pixel tag on a cut line shows where it sits, and its cross removes it.
  1. Click the image where you want a cut. A line appears with its position in pixels, and a small cross to remove it. Drag the line to move it.
  2. Type a number in Every and press Cut, to cut at a fixed interval such as every 1000 px.
  3. Type a number in equal parts and press Cut, to divide the capture into that many even pieces.
  • Equal parts suit a long page you want to share as a set. Every N px suits a fixed-height format, such as a slide.
  • Clear removes every cut, so you can start again. The bar also counts the slices you have made so far.
03

Keep cuts out of lines of text

The Avoid text switch keeps a cut from landing through a line of text. That way a sentence is not split across two images. Leave it on for pages with dense copy, and turn it off when you want a cut at an exact pixel.

04

Rows or columns

The button at the left end of the bar, Cut direction, chooses between two ways of cutting. Rows cuts across, which suits a tall capture. Columns cuts down, which suits a wide one, such as a spreadsheet or a timeline. With columns, the controls switch from heights to widths.

The Cut direction menu open on the left of the slicing bar, offering Rows, cut across, and Columns, cut down
The Cut direction menu: Rows cuts across, Columns cuts down.
05

A ZIP like any other

Press the button that says how many slices it will make, such as Make 4 slices. The result is a slices ZIP, the same numbered archive Slices mode makes, with a manifest of where each piece belongs. Download it, or use Reassemble, which is on the toolbar of every slices capture, to build one image again. Reassemble puts columns back side by side as readily as it stacks rows.

  1. Open a finished capture and choose Slice.
  2. Choose a direction, then click, type an interval, or divide into equal parts.
  3. Press Make slices, then download the ZIP or reassemble the pieces into one image.